[Back to Unofficial System Messages Guide Home]
System Messages – NSX Manager
Module vShield Edge Gateway
Code |
Severity |
Event Message: |
30024 |
Informational |
Configuration changed for : [$component] on vShield Edge with id : edge-# |
Module vShield Edge Health Check
Code |
Severity |
Event Message: |
30033 |
Major |
VShield Edge VM not responding to health check. |
30034 |
Informational |
None of the VShield Edge VMs found in serving state. There is a possibility of network disruption. |
30042 |
Informational |
vShield Edge VM has recovered and now responding to health check. |
Module vShield Edge Appliance
Code |
Severity |
Event Message: |
30152 |
Informational |
vShield Edge system time sync up happens |
Module vShield Edge HighAvailability
Code |
Severity |
Event Message: |
30202 |
High |
vShield Edge HighAvailability switch over happened. VM has moved to ACTIVE state. |
30203 |
High |
vShield Edge HighAvailability switch over happened. VM has moved to STANDBY state. |
Module vShield Edge IPSec
Code |
Severity |
Event Message: |
30401 |
Informational |
IPsec Channel from localIp : <local-endpoint-ip> to peerIp : <peer-end point-ip> changed the status to up |
30402 |
Informational |
IPsec Channel from localIp : <local-subnet-ip> to peerIp : <peer-subnet-ip> changed the status to down |
30403 |
Informational |
IPsec Tunnel from localSubnet : <local-subnet-ip> to peerSubnet : <peer-subnet-ip> changed the status to up |
30404 |
Informational |
IPsec Tunnel from localSubnet : <local-subnet-ip> to peerSubnet : <peer-subnet-ip> changed the status to down |
Like this:
Like Loading...
Related
2 thoughts on “System Messages – NSX Manager”